Skip to main content

A Day of Giving, Dec 19: Volunteer (opens in a new tab) or donate (opens in a new tab)

Arizona licensed · $1M/$2M general liabilityServing Arizona homeowners since 2005Peoria design showroomWritten, itemized project scopesProject-specific payment & warranty terms

Spa Installation in Scottsdale, AZ

Reviewed by the AE Outdoor Living team · Updated Nov 20, 2026

Short answer: A raised spa can send water over a spillway into your Scottsdale pool and share equipment if the plumbing and heater can serve both. An independently heated standalone spa gives you separate temperature control and more choices for placement. We start with how you want to use the spa, then check access, shade and the city’s barrier requirements.

Call (623) 300-2589

Should I build a spa into my pool or give it its own spot?

If you want to move between the pool and spa or see water spill over from the patio, an attached spa is worth drawing first. If you want to soak after dinner while someone swims at a different temperature, compare how a shared system and an independent spa would actually run.

An attached spa can use valves to switch a compatible heater and circulation system into spa mode. In that mode, the design can isolate the smaller body of water for heating. Ask what the pool can still do while the spa is in use. For example, a shared heater can switch to warming the spa while the pool goes without heat. Ask for the operating modes as well as the equipment list.

A standalone spa lets you put the seats closer to the door you use in the evening. A self-contained hot tub also needs a route into the yard, room to open its equipment panel and space to lift or store its cover. Mark those clearances with the patio furniture in place. Our spa and hot tub options guide can help you narrow the choices before we measure.

How high should a raised spillover spa sit?

Choose the height from the approach and the seat, then work out the spillway. From the patio, the raised edge can give you a place to sit and turn into the spa. On the pool side, the same elevation sets how far the water falls. Those are two different views of the same wall.

We mark the water level, seat, entry step and coping on a side-view drawing. Tell us where you want the jets to meet your back and whether you want an upright seat or room to stretch your legs. Then consider the spillway from your dinner table. A wide sheet of falling water can compete with conversation. A narrower opening or a setting that lets you turn the spillover off gives you another choice for a quiet evening.

What changes the cost of adding a spa to an existing pool?

Start with where the spa joins the pool, what the equipment can support and how much finished decking lies between them. A spa beside the equipment pad and a spa across a finished patio can look identical from above and call for very different work.

For an existing pool, we check the shell connection, pipe route, heater and controls before counting on reuse. We also identify which coping and deck sections would come up, and where the new material could end in a clean joint if the original finish is no longer available. For a Scottsdale pool remodel, put those decisions on the same drawing as the new interior finish. If you’re building a pool in Scottsdale, reserving the spa footprint and equipment space from the start gives you the option to build in phases.

Should your spa share the pool equipment? Get an instant price range, Book a time now for an on-site design consultation, or call (623) 300-2589.

What does Scottsdale look for on the spa plan?

Scottsdale requires plans and permits for an in-ground concrete spa. Its site plan instructions ask for distances to the house, property lines and easements, the route into the yard, the material staging area, and the fence location and height. Where the parcel has designated Natural Area Open Space, locate it on the drawing along with any affected native plants.

Access can change the answer even when the spa itself fits. For example, a side yard can be wide enough for equipment while the proposed staging area overlaps protected open space. We look for a workable route before fixing the spa position. Include the heater in the permit discussion, too. Scottsdale calls for a separate plumbing permit for a new gas line serving a spa heater. Licensed trades perform gas, electrical and structural work per the signed scope. Permits are per signed scope. See our Scottsdale pool and spa permit guide.

Where should a spa sit for shade and evening use?

Stand where you expect to sit and look toward the late-afternoon sun. An existing patio cover might shade the seats while leaving the entry ledge in full sun. After sunset, check whether you can see the step edges from the door without a light shining into the eyes of someone in the water.

Leave room for the cover even when it is open. Scottsdale Water recommends covering a pool to reduce evaporation. For a spa, a cover that is easy to handle from the deck is one you can put back on after a soak. If the cover is also part of the approved barrier design, choose the documented safety model and show how it locks. Our pool and spa design page covers the rest of the layout.

Frequently asked questions

Can I add a spa to an existing Scottsdale pool?
Yes, if the site, shell and equipment allow the design you want. Bring the original pool plan and equipment model numbers if you have them. We can compare an attached spa with a separately plumbed one, mark the decking each option disturbs, and identify where a licensed structural professional needs to evaluate the connection.
Does a standalone spa need a barrier?
Scottsdale requires approved protection for standalone spas. Section 305.1 of the city’s pool code allows a lockable spa safety cover that meets ASTM F1346 as an alternative to the enclosure provisions it identifies. Bring the cover’s compliance documentation and the site plan to the city. Check the compliance label even if the seller describes the cover as insulated or locking. A.R.S. §36-1681 also addresses enclosures for qualifying swimming pools.
Is a permit required?
Yes for an in-ground concrete spa. Scottsdale describes a narrow exception for an above-ground fiberglass unit with a plug-in filter and motor, an existing dedicated ground-fault-protected circuit and no direct water connection. New circuits, hardwiring or a water connection change the permit question. Give the city the model and proposed connections before committing to the installation.
Spa now or later?
Build it now if you know where you want to sit and the pool project already opens the plumbing route. If you prefer to wait, keep a dimensioned spa location, a clear path for future lines and enough room at the equipment pad. Ask which provisions are included in the signed scope so a future builder can see exactly what was installed.

Sources

Ready to plan it?


ROC #340966 (R-62) · #341002 (R-3) · #347738 (KA-5) · #211530 (CR-21) · Company facts

Related guides

Keep learning before you build.